Figure 60. Installing the optical drive
After you finish
1. Connect the signal and power cables to the optical drive. See Chapter 6 “Internal cable routing” on page
145
.
2. Complete the parts replacement. See
“Complete the parts replacement” on page 143.
Remove an optical drive cage
Follow instructions in this section to remove the optical drive cage.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
About this task
Attention:
• Read
“Installation Guidelines” on page 29 and “Safety inspection checklist” on page 30 to ensure that you
work safely.
78 ThinkSystem ST45 V3 User Guide
To Next Page
Loading...
