Lenze E84AYCER - Parameter Reference; Communication Module Parameters

Parameter reference
Parameters of the communication module
85
Lenze · E84AYCER communication module (PROFINET) · EDS84AYCER EN 3.0 - 02/2019
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
13 Parameter reference
[ALinkKeywords]
Parameters
This chapter supplements the parameter list and the table of attributes for the Inverter Drive 8400
contained in the software manual and in the »Engineer« online help by the parameters of the com-
munication module E84AYCER (PROFINET).
[Search-Keywords]
Hlp_Para
13.1 Parameters of the communication module
This chapter lists the parameters of the E84AYCER communication module (PROFINET) in numeri-
cally ascending order.
C13000
 Software manual/»Engineer« online help for the Inverter Drive 8400
Here you will find general information on parameters.
 Note!
PROFINET command "Reset to Factory Defaults"
If the "Reset to factory defaults" PROFINET command is executed by an IO supervisor or
an I/O controller, the PROFINET-specific parameters will be reset to their standard va-
lues:
• C13000
| IP address
• C13001
| Subnetwork mask
• C13002
| Gateway address
• C13010
| Active IP address
• C13011
| Active subnetwork mask
• C13012
| Active gateway address
• C13864
| Active station name
• C13887
| Suppress signalling diag. mess. upon
• C13899
| Station name
• C13910
| I&M1 system designation
• C13911
| I&M1 installation site
• C13912
| I&M2 installation date
• C13913
| I&M3 additional information
• C13914
| I&M4 signature code
Parameter | Name:
C13000 | IP address
Data type: UNSIGNED_32
Index: 11575
d
= 2D37
h
Setting of the IP address
Setting the IP configuration
( 38)
Setting range (min. value | unit | max. value) Lenze setting
0 4294967295 0
 Read access  Write access  CINH  PLC-STOP  No transfer  PDO_MAP_RX  PDO_MAP_TX  COM  MOT