Lenze i700 User Manual

Lenze · i700 servo inverter · reference manual · DMS 3.0 EN · 06/2016 · TD06 263
8 Monitoring functions
8.4 Monitoring of the motor utilisation (I²xt)
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
The speed-dependent evaluation of the permissible motor current can actually be switched off by
parameterising all 8 characteristic points to "100 %".
 Stop!
Applications with standard motors
Self-ventilated standard motors are insufficiently protected at low speeds if the speed-
dependent evaluation of the permissible motor current is not effective (all characteristic
points = "100 %").
Applications with PM synchronous motors
Please check for every individual case which r.m.s. value can be used to permanently
operate the motor at standstill.
In case of some motors, a derating I1/In < 100 % is required when n1/nn = 0 %. This
serves to prevent an overload of individual motor phases as their power loss doubles
with continuous DC current load. (It is called DC current load as the field frequency
amounts to 0 Hz at standstill.)

Lenze i700 Specifications

General

Control Type	Vector control, V/f control
Safety	STO (Safe Torque Off)
Protection Class	IP20
Frequency	50/60 Hz
Communication Interfaces	CANopen
Cooling	Air cooled
Protection Features	Overvoltage, Undervoltage
Ambient Temperature	-10°C to +45°C
Frequency Range	0 Hz to 300 Hz
Supply Voltage	3-phase AC