Lenze i700

Lenze · i700 servo inverter · reference manual · DMS 3.0 EN · 06/2016 · TD06 162
5 Motor control & motor settings
5.14 Parameterising the V/f characteristic control
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
0x2BA6 | 0x33A6 - Flying restart: Result
Setting range (min. value | unit | max. value) Lenze setting
0 ms 10000 0 ms
 Write access  CINH  OSC  P  RX  TX UNSIGNED_16
Output of the speed found for acceptance in the control.
• This information is pending until the control reports acceptance of the found speed to the i700 servo inverter via
bit 0 in the Lenze control word (0x2830
or 0x3030 for axis B).
Sub. Name Lenze setting Data type
1 Flying restart: Determined speed [rpm] INTEGER_16
2 Flying restart: Determined speed [n unit] INTEGER_32
Subindex 1: Flying restart: Determined speed [rpm]
Display area (min. value | unit | max. value) Initialisation
-32768 r/min 32767
 Write access  CINH  OSC  P  RX  TX INTEGER_16
Subindex 2: Flying restart: Determined speed [n unit]
Display area (min. value | unit | max. value) Initialisation
-480000 [n unit] 480000
 Write access  CINH  OSC  P  RX  TX
Scaling: 480000/2
31
INTEGER_32