Care, maintenance and disposal
Leuze electronic RSL 430 101
13.2 Cleaning the optics cover
Clean the optics cover as required by the application-related load rating.
Use the cleaning set consisting of special cleaning agent and cleaning cloths for cleaning (see chapter 17
"Order guide and accessories").
The procedure for cleaning depends on the kind of contamination:
Soiling Cleaning
Particles, loose, scouring Vacuum without touching or blow away softly, oil-free
Wipe free in one swipe with cleaning cloth
Particles, loose, non-scouring Vacuum without touching or blow away softly, oil-free
or
Wipe free in one swipe with cleaning cloth
Particles, sticking Wet with cloth soaked in cleaning agent
Wipe free in one swipe with cleaning cloth
Particles, statically charged Vacuum without touching
Wipe free in one swipe with cleaning cloth soaked with cleaning
agent
Particles/drops, smearing Wet with cloth soaked in cleaning agent
Wipe free in one swipe with cleaning cloth
Water drops Wipe free in one swipe with cleaning cloth
Oil drops Wet with cloth soaked in cleaning agent
Wipe free in one swipe with cleaning cloth
Fingerprints Wet with cloth soaked in cleaning agent
Wipe free in one swipe with cleaning cloth
Scratches Change optics cover
NOTICE
The wrong cleaning agents or cloths will damage the optics cover!
Ä Do not use any scouring cleaning agents or scratching cloths.
NOTICE
If cleaning takes longer than four seconds, e.g. with fingerprints, the safety sensor displays a
fault of optics cover monitoring. After cleaning is complete, the safety sensor resets itself auto-
matically.
Ä Clean the optics cover over the entire 360° range.
Ä Soak cloth with cleaning agent.
Ä Wipe optics cover free in one swipe.
To Next Page
Loading...
