Device description
Leuze electronic RSL 430 19
3.4.3
Field-of-view display
The upper and lower limit of the safety sensor's field of view can be displayed by means of horizontal lines
on the optics cover.
Ä Make sure that the safety sensor's field of view is always completely unobstructed.
NOTICE
Always check the protective field configuration!
Ä Check all defined protective fields each time the configuration is changed.
The field-of-view display is a comfort function and is not intended as a substitute for check-
ing the protective field configuration.
Ä The safety sensor's field of view must be completely unobstructed on the application side.
3.5 Mounting system (optional)
Mounting systems and mounting brackets simplify mounting and alignment of the safety sensor. Mounting
systems and mounting brackets are available as accessories (see chapter 17 "Order guide and acces-
sories").
3.6 Loop guard (optional)
The loop guard for the optics cover prevents damage to the safety sensor caused by light contact with for-
eign objects. The loop guard is available as an accessory (see chapter 17 "Order guide and accessories").
To Next Page
Loading...
