Leuze electronic RSL 430 - Settings

Configuration and diagnostic software SensorStudio
Leuze electronic RSL 430 29
Create and save service file
The service file contains all available information on the safety sensor as well as configuration and settings.
When requesting support, send the service file to the Leuze electronic customer service (see chapter 14
"Service and support").
Sensor display
Device display in the DTM menu
• SENSOR DISPLAY
• STATE OF THE ACTIVE PROTECTIVE AND WARNING FIELDS
• SENSOR DATA
Diagnostics list
Access list
EventLog
4.5.6 SETTINGS
NOTICE
You can only transfer changes made in the SETTINGS menu to the safety sensor if you are
logged in with the access level Engineer.
Communication
• LAN
• DHCP
• CONNECTION SETTINGS
• MAC address
• USB
• DHCP
• CONNECTION SETTINGS
• Sensor data
• Bluetooth
• Activate Bluetooth module
• Activate device scan
• Bluetooth address
Data telegrams
A UDP telegram can be configured which sends the status profile of the safety sensor as well as the mea-
surement data to a receiving device connected via Ethernet, e.g. to a PC.
EventLog
Trigger signals output when certain events occur, are recorded and shown in the event list of the safety
sensor.
Information on the monitored signals can be found in the information area and in the online help. Select the
Help menu item in the menu [?].
Sensor display
Activation of the safety sensor alphanumerical display.
Information on the display options can be found in the information area and in the online help. Select the
Help menu item in the menu [?].