Leuze electronic RSL 430 - Servicing; Disposing

Care, maintenance and disposal
Leuze electronic RSL 430 102
Ä Clean not only the optics cover, but also the reflector ring under the cap.
1
1 Reflector ring
Fig.13.1: Reflector ring
NOTICE
Internal monitoring of optics cover!
Ä The monitored area is dependent on the configuration and can be smaller than the entire
scanning range of 270°.
Ä On account of device safety, the internal monitoring of the optics cover monitors a range
that is larger than specified by the configured protective field.
13.3 Servicing
The device does not normally require any maintenance by the operator.
Repairs to the device must only be performed by the manufacturer.
Ä For repairs, contact your responsible Leuzeelectronic subsidiary or Leuzeelectronic customer service
(see chapter 14 "Service and support").
13.4 Disposing
Ä For disposal observe the applicable national regulations regarding electronic components.