Diagnostics and troubleshooting
Leuze electronic RSL 430 97
Diagnostic
ID
Diagnostic message Measure
P0414 Safety configuration is not compatible: un-
known EDM inputs.
Swap out the safety sensor or change the
configuration. The type of safety sensor must
be the same as the type stored in the connec-
tion unit or in the Sensor Studio software.
P0415 Safety configuration is not compatible: un-
known field pair monitoring mode.
Swap out the safety sensor or change the
configuration. The type of safety sensor must
be the same as the type stored in the connec-
tion unit or in the Sensor Studio software.
P0416 Safety configuration is not compatible: un-
known field pair monitoring parameters.
Swap out the safety sensor or change the
configuration. The type of safety sensor must
be the same as the type stored in the connec-
tion unit or in the Sensor Studio software.
P0417 Safety configuration is not compatible: un-
known field pair monitoring mode.
Swap out the safety sensor or change the
configuration. The type of safety sensor must
be the same as the type stored in the connec-
tion unit or in the Sensor Studio software.
P0419 Safety configuration is not compatible: un-
known monitoring parameter for the
changeover order.
Swap out the safety sensor or change the
configuration. The type of safety sensor must
be the same as the type stored in the connec-
tion unit or in the Sensor Studio software.
P0420 Safety configuration is not compatible: un-
known monitoring mode of the field pair
changeover.
Swap out the safety sensor or change the
configuration. The type of safety sensor must
be the same as the type stored in the connec-
tion unit or in the Sensor Studio software.
P0421 Safety configuration is not compatible: un-
known parameter for field pair changeover
monitoring.
Swap out the safety sensor or change the
configuration. The type of safety sensor must
be the same as the type stored in the connec-
tion unit or in the Sensor Studio software.
P0422 Safety configuration is not compatible: un-
known field pair selection mode.
Swap out the safety sensor or change the
configuration. The type of safety sensor must
be the same as the type stored in the connec-
tion unit or in the Sensor Studio software.
P0423 Safety configuration is not compatible: un-
known field pair selection parameter.
Swap out the safety sensor or change the
configuration. The type of safety sensor must
be the same as the type stored in the connec-
tion unit or in the Sensor Studio software.
P0424 Safety configuration is not compatible: un-
known parameter for manipulation monitor-
ing.
Swap out the safety sensor or change the
configuration. The type of safety sensor must
be the same as the type stored in the connec-
tion unit or in the Sensor Studio software.
P0425 Safety configuration is not compatible: un-
known configuration of the output signals.
Swap out the safety sensor or change the
configuration. The type of safety sensor must
be the same as the type stored in the connec-
tion unit or in the Sensor Studio software.
P0426 Safety configuration is not compatible: un-
known resolution.
Swap out the safety sensor or change the
configuration. The type of safety sensor must
be the same as the type stored in the connec-
tion unit or in the Sensor Studio software.
P0427 Safety configuration is not compatible: un-
known parameter.
Swap out the safety sensor or change the
configuration. The type of safety sensor must
be the same as the type stored in the connec-
tion unit or in the Sensor Studio software.
To Next Page
Loading...
