Repair information 4-67
5025-2xx, 4xx
Installation notes:
1. Place the left side of the ACM in the printer. Make sure the shaft on the left side aligns with the hole in the
frame.
2. Install the two springs.
3. Reinstall the three screws holding the ACM to the printer.
4. Turn the printer to the proper upright position.
5. Reroute the cable, making sure to place the cables into the two retainers on the left side.
6. Remove the rear shield, and reconnect the cable.
7. Replace the rear shield.
To Next Page
Loading...
