3-14 Service Manual
5056-XXX
Finisher Tests
Feed Test
This test feeds one sheet of media from the device’s default input source to a finisher output bin. The device can
perform this test using any paper size that is supported by the finisher. No information is printed on the test
page.
Note: A user cannot specify the output bin to which the device will feed the test page.
The test cannot be canceled while it is running. As a result, no buttons are active during the execution of this
test.
While this test executes, the power indicator light flashes green, and the panel displays “Feed Test Running”.
Hole Punch Test
This test is used to verify that media can be fed to a finisher output bin and then hole-punched. No information is
printed on the feed test pages since the laser isn’t engaged during this test. Eight sheets of paper are fed, and
then the pages are hole-punched with a 3-hole or a 4-hole pattern depending on the selected punch test.
Note: The printer will use Letter-size paper for the 3-hole punch test and A4-size paper for the 4-hole punch
test.
The Finisher Feed Test cannot be canceled or terminated when execution of the test has begun. As a result, no
buttons are active during the execution of this test. While this test runs, the power indicator light flashes green,
and the panel displays “Hole Punch Test Running”.
Sensor/Sw Test
This test is used to verify that the finisher’s sensors and switches are working properly. When the Sensor/Sw
Test item is selected, the panel displays the following options:
• Finisher Devices
• Finisher Path
• Finisher Bin
Use the key to select one of the above options. The panel will display all of the sensor names listed next, as well
as each sensor’s current state.
To Next Page
Loading...
