Diagnostic aids 3-19
5056-XXX
When you are finished setting the configuration ID, press the key. This will save the setting.
Note: Do not press the Back key before pressing the key. Doing this will result in the new setting not being
saved.
After one or both configuration ID settings are saved, the printer will not POR. After saving the new configuration
ID, press the Back key to return to the Printer Setup menu.
Reset Color Calibration
This setting enables the printer to adjust the alignment of its color planes using pre-programmed default values.
Using this setting to adjust color plane linearization may not provide as effective a calibration as would using the
“Automatic Alignment Adjust”. To perform this adjustment, press the key.
Par [x] Strobe Adj.
This setting enables the user to adjust the amount of time the strobe is sampled in order to determine if valid
data is available on the parallel port. The settings range from -4 to +6. Each time this value is incremented by 1,
the strobe is sampled 50 ns longer. Each time this value is decreased by 1, the strobe is sampled 50 ns less.
When the value of this setting is 0, the factory default value is used to determine the length of time the strobe is
sampled.
Par S Strobe Adj
This message displays only if the printer is configured with the standard parallel port.
Par 1 Strobe Adj
This message displays only if a parallel port is available through the PCI slot 1.
Par 2 Strobe Adj
This message displays only if a parallel port is available through the PCI slot 2.
Par 3 Strobe Adj
This message displays only if a parallel port is available through PCI slot 3.
To adjust one of these settings, select Par [x] Strobe Adj from the Printer Setup menu. This screen will display: (x
equals the number of the strobe being adjusted)
1. Press the or arrow keys to increase or decrease the Strobe Adj value.
2. When the desired number is displayed, press the key to save the value.
Note: Do not press the Back key before pressing the key. Doing this will result in the new setting not
being saved.
3. Press the Back key to return to the Printer Setup menu.
To Next Page
Loading...
