3-22 Service Manual
5056-XXX
Factory defaults
Enables a user to restore all the printer’s settings to either network or base printer settings.
When “Restore Base” is selected, all non-critical base printer NVRAM settings are restored.
When “Restore Network” is selected, all network NVRAM settings are restored to their factory default values.
To restore default settings, use the key or to scroll to the base or network defaults and press the
key.
Note: The “Restore Network” option is only available on models with an integrated network adapter.
Energy conserve
Energy conserve affects the values that appear on the “Power Saver” menu in the setup menu. To activate or
deactivate this item, use the or key to scroll to the desired setting, and press the key.
This setting only appears when the printer does not support “Automatic Power Saver”, or the “Automatic Power
Saver” feature has been deactivated.
Event log
The event log prints when the key is pressed.
Auto align adjust
This setting determines whether the printer performs an auto align adjust calibration after a certain initiating
event such as a POR, close door, or new toner cartridge detection. The settings are on and off. Use the or
key to scroll to the desired setting, then press the key.
Note: Auto align adjust should never be off during normal printer usage.
Auto color adjust
auto color adjust determines whether the printer should perform an automatic color calibration after an initiating
event occurs. The settings for this option are on and off. Use the or key to scroll to the desired setting,
then press the key.
Note: Auto color adjust should never be off during normal printer usage.
Paper prompts
Paper prompts controls the tray to which the printer directs a change paper prompt. The values for this setting
are Auto, MP Feeder, and Manual Paper. Use the or key to scroll to the desired value, then press the
to accept the change.
Envelope prompts
Envelope prompts controls the tray to which the printer directs an envelope change prompt. The values for this
setting are Auto, MP Feeder, and Manual Paper. Use the or key to scroll to the desired value, and
press the key to accept the change.
To Next Page
Loading...
