Lexmark C920 - Page 79

Diagnostic information 2-37
5056-XXX
Serial <x> See action column. A serial interface is the active
communication link.
Some held jobs were lost The printer frees memory by
deleting the oldest held job and
continues deleting held jobs until
there is enough printer memory to
process the job.
-Select Continue to clear the
message and continue printing.
-Cancel the current job.
Staples Empty Staple cartridge status message -Install a new staple cartridge.
-Select Continue to clear the
message and continue printing
without stapling.
-Cancel the current job.
Staples Low
Standard Bin Full Output bin full. Remove the stack of paper from the
bin to clear the message.
Submitting selection The printer is processing a
selection request.
Wait for the message to clear.
Transfer Belt Life Warning The transfer belt is nearing the
end of life.
-Select Continue to clear the
message and print without installing
a new transfer belt.
-Replace the transfer belt and, if
necessary, reset the printer internal
counter for the transfer belt.
Tray <x> Empty The specified paper tray is empty. Load paper in the tray to clear the
message.
Tray <x> Low The specified paper tray is low. Add paper to the tray to clear the
message.
Tray <x> Missing The specified paper tray is
missing or improperly installed.
Insert the tray into the printer.
USB See action column. The printer is processing data
through the specified USB port.
USB <x>
USB drive removed -Wait for the message to clear.
-Insert the USB drive.
View supplies Displays the current level of all
printer supplies.
Waiting The printer has received a page of
data to print, but is waiting for an
End of Job command, a Form
Feed command, or additional
data.
-Press Select to print the contents of
the buffer.
-Cancel the current job.
1565 Emul Error
Load Emul Option
The printer automatically clears
the message in 30 seconds, and
then disables the download
emulator on the firmware card.
Download the correct download
emulator version from the Lexmark
Web site.
30 Coating roll missing The coating roll in the fuser is
improperly installed or missing.
Install the coating roll, and close the
top cover.
30 <color> print unit missing The specified color print unit is
improperly installed or missing.
Install the specified print unit, and
close the top cover.
34 Incorrect media -Load the appropriate media in the
selected source.
-Select Continue to clear the
message and print the job using a
different paper source.
Message Meaning Action