Actions Yes No
Step 7
Perform a print test.
From the Diagnostics menu, select PRINT TESTS > Tray [x].
Note: [x] refers to the tray where the skewed prints are sourced
from.
Does the problem remain?
Go to step 8. The problem is
solved.
Step 8
Adjust the margins.
From the Diagnostic menu, select REGISTRATION.
Does the problem remain?
Go to step 15. The problem is
solved.
Step 9
Check the guides in the MPF tray.
Does the position of the guides match the paper loaded?
Go to step 11. Go to step 10.
Step 10
Adjust the guides to match the paper loaded.
Does the problem remain?
Go to step 11. The problem is
solved.
Step 11
Check if the printer supports the paper loaded.
Note: For a complete list of supported paper, see the printer
User’s Guide.
Is the paper supported?
Go to step 13. Go to step 12.
Step 12
Remove the paper, and then load a supported one.
Does the problem remain?
Go to step 13. The problem is
solved.
Step 13
Check the MPF pick roller for excess wear and contamination.
Is the MPF pick roller free from excess wear and contamination?
Go to step 15. Go to step 14.
Step 14
Replace the MPF pick roller. See
“MPF pick roller and separator
pad removal” on page 209.
Does the problem remain?
Go to step 15. The problem is
solved.
4600-830, -835, -895
Diagnostics and troubleshooting
47