2-20 Service Manual
4060-xxx
Check Duplex
Connection
This messages displays for the following conditions:
• The duplex option may have been removed from
the printer, possibly to clear a paper jam or to
remove the option.
• The duplex option may be attached to the printer
but a communications problem may prevent the
printer from detection. For example, there may be a
poor connection or a hardware failure.
The following actions may be taken:
• If the option was temporarily removed or not
connected properly, reattach or reconnect it.
• Press Go to execute a configuration change which
notifies the printer the option has been hot
unplugged (removed with the power on).
Note: This action is not available if the printer is in
Diagnostics Mode or running diagnostics.
• If the device is experiencing a hardware problem,
turn the printer off and on. If the message
continues to be displayed, go to “Duplex option
service check” on page 2-47.
Check Tray x
Connection
Tra y x=Tray 2, Tray 3, Tray 4, or Tray 5
This messages displays for the following conditions:
• The specified device may have been removed from
the printer, possibly to clear a paper jam or to
uninstall the option.
• The option may be attached to the printer but a
communications problem may prevent the printer
from detecting the option. For example, there may
be a poor connection or a hardware failure.
The following actions may be taken:
• If the option was temporarily removed or not
connected properly, reattach or reconnect it.
• Press Go to execute a configuration change which
notifies the printer the option has been hot
unplugged (removed with the power on).
Note: This action is not available if the printer is in
Diagnostics Mode or running diagnostics.
• If the device is experiencing a hardware problem,
turn the printer off and on. If the message
continues to be displayed, go to “Input tray(s)
service check” on page 2-64.
Close Finisher Side
Door
Close the finisher side door. If the message does not
clear automatically when the door is closed, go to
“StapleSmart finisher service check” on page 2-86.
Close Finisher Top
Cover
Close the finisher top cover. If the message does not
clear automatically when the cover is closed, go to
“StapleSmart finisher service check” on page 2-86.
Delete All Jobs
Go/Stop?
When the user has selected the Print and Hold Delete
All Jobs selection, this message is displayed. The
following actions may be taken:
• Press Go to confirm the selection. All jobs are
deleted.
• Press Return or Stop to cancel the delete
operation.
User attendance messages (continued)
Primary message Secondary message Explanation
To Next Page
Loading...
