Diagnostic information 2-21
4060-xxx
Disk Corrupted
Reformat?
The printer has detected there are errors on the hard
disk that cannot be corrected. The disk cannot be used
until it is reformatted.
Warning: All data on the disk will be lost if you format
the disk.
The following actions can be taken:
• Power off and remove the disk. The disk will not be
formatted.
• Press Go to format the disk. All data is lost when
you format the disk.
Empty Box M This message is displayed when the hole punch alarm
is on and the printer informed by the code the hole
punch box M is full. The following actions may be
taken:
• Empty the hole punch box.
• Press Go to ignore the message. The Box M Full
appears on line 2 of the display and the job is
printed without hole punching. The message
remains until the box is emptied.
If this message continues to be displayed when the
box has been emptied, go to “StapleSmart finisher
service check” on page 2-86.
Insert Box M This message is displayed when the hole punch box is
missing or installed incorrectly. The message is
displayed during any of the following times, regardless
of the hole punch alarm setting:
• At POST
• After the finisher side door has been closed
• Before the first page of a job requesting hole
punch. The message displays once per job.
The following actions can be taken:
• Install the hole punch box.
• Press Go to ignore the message. The Box M
Missing message appears on the status line. A job
that is set for hole punching will not be punched.
The message continues to display on all
subsequent jobs that request hole punching.
If this message cannot be cleared after inserting the
box, go to “StapleSmart finisher service check” on
page 2-86.
Insert Cartridge or Close
Door
This message displays when the printer front door is
open or the print cartridge is missing.
If this message cannot be cleared, go to “Cover
closed switch/cable service check” on page 2-44.
Insert Staple Cartridge This message displays when the staple cartridge is
missing or installed incorrectly. The message appears,
regardless of the Staple Alarm setting, at the following
times:
•At POR
• After the Stapler Door has been closed.
The following actions can be taken:
• Install the stapler cartridge.
• Press Go to clear the message. The printer
handles stapled jobs as if the staple cartridge were
installed, but empty. The Staples Empty message
appears on the status line and the Load Staples
may display.
User attendance messages (continued)
Primary message Secondary message Explanation
To Next Page
Loading...
