2-22 Service Manual
4060-xxx
Insert <tray><tray>=Tray 1, Tray 2, Tray 3, Tray 4, or Tray 5.
The printer detects a tray needs to be inserted. The
printer does not continue until it detects the tray is
inserted.
Note: This situation usually occurs when the tray is
refilled during a job. To refill a tray during a printing
session, press Stop and wait for pages to reach the
output bin before refilling the tray.
The following actions may be taken:
• Insert the requested tray.
• Press Menu until Busy/Waiting displays. The
following selections are available:
-Cancel Job
- Reset Printer
- Reset Active Bin
If the message cannot be cleared, go to “Internal tray
card/paper size sensing service check” on
page 2-66 or “Input tray(s) service check” on
page 2-64.
Install Bin x
or Cancel Job
Bin x=Bin 1, Bin 2, or Bin 3.
This message is displayed when a paper handling
option has been hot unplugged. The printer requires
the reinstallation of the option to print a page which
has been formatted by the interpreter before the option
was removed.
The following actions may be taken:
• Install the option.
• Press Menu until Busy/Waiting displays. Select
one of the following:
-Cancel Job
- Reset Printer
- Reset Active Bin
If the message cannot be cleared, go to “Input tray(s)
service check” on page 2-64.
Install Duplex
or Cancel Job
This message is displayed when a duplex option has
been hot unplugged. The printer requires the
reinstallation of the option to print a page which has
been formatted by the interpreter before the option
was removed.
The following actions may be taken:
• Install the duplex option.
• Press Menu until Busy/Waiting displays. Select
one of the following:
-Cancel Job
- Reset Printer
- Reset Active Bin
If the message cannot be cleared, go to “Duplex
option service check” on page 2-47.
Install Env Feed
or Cancel Job
This message is displayed when the envelope feeder
has been hot unplugged. The printer requires the
reinstallation of the feeder to print a page which has
been formatted by the interpreter before the feeder
was removed.
The following actions may be taken:
• Install the envelope feeder.
• Press Menu until Busy/Waiting displays. Select
one of the following:
-Cancel Job
- Reset Printer
- Reset Active Bin
If the message cannot be cleared, go to “Envelope
feeder service check” on page 2-49.
User attendance messages (continued)
Primary message Secondary message Explanation
To Next Page
Loading...
