2-30 Service Manual
4060-xxx
200 Paper Jam
Remove Cartridge
Leave Job in Finisher Primary: Paper is jammed at the printer input sensor.
Open the printer upper front door and remove the print
cartridge to access the paper jam area.
Secondary: When this message is displayed, do not
remove accumulated sheets during the jam clearance
procedure as the printer will not reprint the removed
sheets. Also, if the accumulated sheets are removed,
the portion of the job printed after the jam will not be
stapled.
201 Paper Jam
Remove Cartridge
Leave Job in Finisher Primary: Paper is jammed between the printer input
and exit sensors. Open the printer upper front door and
remove the print cartridge to access the jam area.
Secondary: When this message is displayed, do not
remove accumulated sheets during the jam clearance
procedure as the printer will not reprint the removed
sheets. Also, if the accumulated sheets are removed,
the portion of the job printed after the jam will not be
stapled.
202 Paper Jam
Open Rear Door
Leave Job in Finisher Primary: Paper is jammed at the printer exit sensor.
Open the printer rear door to access the jam area.
Secondary: When this message is displayed, do not
remove accumulated sheets during the jam clearance
procedure as the printer will not reprint the removed
sheets. Also, if the accumulated sheets are removed,
the portion of the job printed after the jam will not be
stapled.
231 Duplex Paper Jam -
Rear
Leave Job in Finisher Primary: A piece of media did not arrive at the duplex
input sensor, but did leave the printer exit sensor.
Secondary: When this message is displayed, do not
remove accumulated sheets during the jam clearance
procedure as the printer will not reprint the removed
sheets. Also, if the accumulated sheets are removed,
the portion of the job printed after the jam will not be
stapled.
232 Duplex Paper Jam -
Rear
Leave Job in Finisher Primary: A piece of media did not clear the duplex
input sensor but did leave the printer exit sensor.
Secondary: When this message is displayed, do not
remove accumulated sheets during the jam clearance
procedure as the printer will not reprint the removed
sheets. Also, if the accumulated sheets are removed,
the portion of the job printed after the jam will not be
stapled.
233 Duplex Paper Jam -
Rear
Leave Job in Finisher Primary: A piece of media failed to make the duplex
double feed sensor during turnaround.
Secondary: When this message is displayed, do not
remove accumulated sheets during the jam clearance
procedure as the printer will not reprint the removed
sheets. Also, if the accumulated sheets are removed,
the portion of the job printed after the jam will not be
stapled.
234 Duplex Paper Jam -
Rear
Leave Job in Finisher Primary: The media did not reach the duplex exit
sensor.
Secondary: When this message is displayed, do not
remove accumulated sheets during the jam clearance
procedure as the printer will not reprint the removed
sheets. Also, if the accumulated sheets are removed,
the portion of the job printed after the jam will not be
stapled.
User attendance messages (continued)
Primary message Secondary message Explanation
To Next Page
Loading...
