2-66 Service Manual
4062
27x.51
x = bin
number
Right tamper does not
leave home position
failure
Applies to:
Offset stacker
The sensor (right tamper HP)
does not detect that the tamper
has moved from home position.
1. Check all the connections on
the output option controller
card.
2. Check the tamper drive belt
for damage and replace if
needed.
3. Replace the right tamper
motor assembly.
Go to “SFP stapler assembly
tamper drive motor
assembly removal” on
page 4-126.
4. Replace the sensor (tamper
HP).
Go to “SFP stapler assembly
sensor (tamper HP left and
right) removal” on
page 4-134.
4. Replace the output option if
problem remains.
271.52
x = bin
number
Sensor (mailbox
empty) lingering jam
Applies to:
Mailbox
The media reached the sensor
(mailbox empty) but did not
clear it in the specified time.
See “Sensor (mailbox empty)
lingering jam service check”
on page 2-144.
27x.53
x = bin
number
Sensor (mailbox
empty) late jam
Applies to:
Mailbox
The media is late reaching the
sensor (mailbox empty) within
the specified time.
See “Sensor (mailbox empty)
late jam service check” on
page 2-143
27x.54
x = bin
number
Sensor (output pass
through) lingering jam
Applies to:
Mailbox
The media reached the sensor
(output pass through) but did
not clear it in the specified time.
See “Sensor (output pass
through) lingering jam
service check” on
page 2-141.
27x.55
x = bin
number
Sensor (mailbox
empty) lingering jam
Applies to:
Mailbox
The media reached the sensor
(mailbox empty) but did not
clear it in the specified time.
See “Sensor (mailbox empty)
lingering jam service check”
on page 2-144.
27x.58
x = bin
number
Sensor (output pass
through) late jam
Applies to:
Mailbox
High capacity stacker
Offset stacker
Output expander
The media is late reaching the
sensor (output pass through)
within the specified time.
See “Sensor (output pass
through) late jam service
check” on page 2-140.
28x.25
x = bin
number
Invalid ejector motor
manager status.
Applies to:
StapleSmart finisher
A software failure has occurred
with the output option.
1. Turn the machine off/on.
2. Replace the output option if
problem remains.
Error
code or
message
Error contents Description/Action Possible repair actions
To Next Page
Loading...
