Basic System Setup4
Step 1 of 2 — Option B: Connecting cameras to your local network using power adapters:
1. Connect each camera to a compatible power adapter (check your camera documentation at
lorex.com for compatible power adapters for your cameras).
2. Connect the camera to your router using a CAT5e or higher Ethernet cable.
Step 2 of 2: Add the cameras to your NVR:
1. Right-click and select Device Search.
2. Click Device Search. The system searches the network for compatible cameras.
NOTE
It may take a few minutes after you power up IP cameras for them to appear in your search.
#LX400113; r. 1.0/56015/56022; en-US 11
To Next Page
Loading...
Need help?
General