106
Under normal
usage,
you
should
never
need
to change the clock setting unless
you
cross
over
into a
new
time
zone.
The
eXplorist receives its clock information from the atomic clock
located
in
the
GPS
satellite
and
is
extremely accurate.
Other then changing the time for
when
you
cross
time
zones,
you
can
also
set
the format that
the time
is
displayed
as
well
as
select the daylight savings time settings.
Setting the Time & Format
To
adjust the time
you
must first select a format that the time will
be
displayed in. If the
format
you
are
presently
usi
ng
is
the format
you
want to
keep,
you
sti
II
need
to verify the
format before
you
can
set
the clock.
1.
Press
MENU.
2.
Use
the Arrow joystick to highlight Preferences.
3.
Press
ENTER.
4.
Use
the Arrow joystick to highlight Clock.
5.
Press
ENTER.
6.
Use
the Arrow joystick to highlight the
Format
field.
7.
Press
ENTER.
8. Select Local
24
Hrs,
Local
AM/PM,
or
UTe.
9.
Press
ENTER.
10. With the clock field highlighted,
press
ENTER.
11.
Use
the Arrow joystick to
set
the time.
(Up/down changes the value
at
the cursor location; left/right
moves
the cursor.)
12.
When
the time
is
set
properly,
press
ENTER.
13. With the Done button highlighted,
press
ENTER.
To Next Page
Loading...
