Mahr Digimar 816 CL User Manual

18
Mahr GmbH • Digimar 816 CL
EN
2.1 Switching ON
– Switch the mains power supply to ON = (1).
The switch which can be found at the rear of the height measuring
instrument
– The Boot up sequence will be start.
– The measuring carriage of the height measuring instrument will
move automatically to the reference point and set the zero point
on the base plate.
Note: Once the zero point has been accepted, confirmation is
given by 2 acoustic signals (beep).
After the reference point has been confirmed, any zero point
can be selected.
2. Commissioning / First steps
Description / Sequence Symbols / Pictures
2
1

Mahr Digimar 816 CL Specifications

General

Brand	Mahr
Model	Digimar 816 CL
Category	Measuring Instruments
Language	English