GROVE 1-3
CD3340B/YB4411 INTRODUCTION
Published 04/07/2015 Control # 569-00
ENGINE OIL SPECIFICATIONS
Oil Performance Recommendations
The use of quality engine lubricating oils combined with
appropriate oil and filter change intervals are critical factors
in maintaining engine performance and durability.
It is recommended that a high quality SAE 15W-40 heavy
duty engine oil which meets the American Petroleum
Institute (API) performance classification CE/SG.
NOTE: CF-4, CH-4, CI-4, or CJ-4 engine oils can be used
in areas where CE oil is not available, but the oil
change interval must be reduced to one half the
interval given in the maintenance schedule.
A sulfated ash limit of 1.0 mass percent is
suggested for optimum valve and piston deposit
and oil consumption control. The sulfated ash must
not exceed 1.85 mass percent.
Oil Viscosity Recommendations
The use of multi-viscosity lubricating oil has been found to
improve oil consumption control and improve engine
cranking in cold temperatures while maintaining lubrication
at high operating temperatures.
While 15W-40 oil is recommended for most climates, refer to
the viscosity recommendations for extreme climates
(Figure 1-2).
NOTE: Limited use of low viscosity oils, such as 10W-30
may be used for easier starting and providing
sufficient oil flow at ambient temperatures below -
5°C (23°F). However, continuous use of low
viscosity oils can decrease engine life due to wear.
New Engine Break-In Oils
Do not use special “break-in” lubricating oils for new or
rebuilt engines. Use the same type of oil during the “break-in”
as that which is used in normal operation.
Wire Rope (Optional Below Deck Winch)
Diameter.......................................................................... 8 mm (5/16 in)
Length ............................................................................. 30.5 m (100 ft)
Torque Converter
Model............................................................................... Borg Warner
Type................................................................................. Hydraulic
Transmission
Type................................................................................. International Transmissions Limited
Model............................................................................... PS-750
Type................................................................................. Powershift
Travel Speed
First............................................................................. 7.14 km/h (4.6 mph)
Second........................................................................ 13.0 km/h (8.1 mph)
Third............................................................................ 23.0 km/h (14.3 mph)
Fourth ......................................................................... 37.7 km/h (23.4 mph)
Front Axle, Drive/Steer
Type................................................................................. Carraro
Model............................................................................... 26.18M-164
Ratio................................................................................ 10.66:1
Reference Only
To Next Page
Loading...
Need help?
General
