Manitowoc Grove GMK 5250L Maintenance Manual

Maintenance work on the carrier
7.9 Axle lines
7 - 70 3 302 744 en Maintenance manual
GMK5250L
09.03.2018
7.9.6 Lubricating the cardan shafts in the axle lines
H
Check all cardan shafts to see if they have grease nipples.
Cardan shafts with grease nipples must be serviced, cardan shafts without
grease nipples are maintenance-free.
Grease, spare
parts, tools
– Grease gun from the tool set.
Prerequisites – The truck crane must be raised on outriggers or parked over an inspection
pit.
– The engine must be switched off and secured against unauthorised use;
à p. 2 - 3.
– The wheels must be turned as far as they will go, so that the lubricating
nipples on the sides of the final drives are more easily accessible.
Greasing
Cardan shafts (2) are fitted only to the
10 x 8 x 10 drive.
• Check which cardan shafts (1) and (2) have
lubricating nipples (3).
• Clean the grease nipples (3).
• Inject grease into the grease nipples until
grease escapes from the bearing points.
Do not inject grease with excessive force,
otherwise the lip seals may be damaged.
• Remove the excess grease.
M 1
Lubricating
grease
Designation to
DIN 51502
Specification
Classification
GROVE part no.
Grease KP - 1K - 50 DIN 51825 03233369

Manitowoc Grove GMK 5250L Specifications

General

Brand	Manitowoc
Model	Grove GMK 5250L
Category	Construction Equipment
Language	English