Grove Published 01-29-2015, Control # 512-01 6-21
TMS700E SERVICE MANUAL SWING SYSTEM
the gear teeth when the control pedal is pushed down. Verify
all attaching hardware is secure and undamaged. Make
adjustments as needed.
If the swing lock assembly is damaged, install a replacement.
Align the blade of the swing lock assembly so it will fall
between gear teeth. Use the shim and the related attaching
hardware (two 5/16-18 screws and 5/16 ID lockwashers) to
ensure the swing lock assembly stays in place and can lock
up the superstructure. Tighten the four mounting bolts; refer
to Fasteners and Torque Values, page 1-12 for the torque
value.
Reference Only
To Next Page
Loading...
