Manitowoc Published 05-26-17, Control # 238-02 3-17
MLC165-1 SERVICE/MAINTENANCE MANUAL ELECTRICAL SYSTEM
TEST VOLTAGES
Node Heading Descriptions
The following are descriptions of the headings of the tables
on the following pages.
The Receptacle Number — indicates the CAN Bus system
node number, cable, receptacle number, and pin number
code (34-R) is as follows:
The number 34 is the cable number.
The number 3 is the node number.
The number 4 is the receptacle number where item is
located on the node.
The last number R is the pin number of the receptacle.
Function Type — indicates the type of connection - such as
power, ground, analog output (AO), analog input (AI), digital
input (DI), or digital output (DO).
Receptacle/Pin No.— (Engine Node 0 only) indicates input to
receptacle number and pin number code (J2-1).
Wire No. — (Engine Node 0 only) indicates wire to computer
receptacle (0107) or wire number code (6C12A).
Description — indicates the component item.
CAN Packet Number — indicates location of items for
master node 1, node 2, universal nodes (3 and 4), boom
remote input node and luffing jib remote input node. Engine
node 0 does not have packet code numbers.
Master node 1:
CAN92-6-32 (Swing Park Switch) indicates where the
inputs/outputs are located on the node.
CAN92 is the packet location number.
Number 6 is the bank where information is stored.
Number 32 is the identifier for that item.
To Next Page
Loading...
