Mark-10 F Series - Page 22

Series F Test Frames + IntelliMESUR
®
Software User’s Guide
22
TOC 
Select this button to log out and log in as a new user.
6.2.2 User Permission Levels
IntelliMESUR provides three user permission levels, summarized as follows:
Operator
Supervisor
Administrator
Manual Control
X
X
X
Recall and run a test
X
X
X
Create a test
X
X
Create a report
X
X
X
Calibration
X
X
Update software
X
User management
X
User name Admin is pre-installed, with Administrator level access. The default password is admin, and
may be changed if desired. Refer to the following sections for instructions.
6.2.3 Adding a User
Select Add User. The screen appears as follows:
Specify the user name, type, and password, then select Add User.
To modify a user, select Modify User. The screen appears as follows:
Select the user, then modify the user type, change the password, and/or delete the user. Note that the
user Admin cannot be deleted.
To change the password, select Change Password. The screen appears as follows:
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com