Matrix Sparsh VP110

128 Matrix SPARSH VP110 User Guide
Failover Mode
• Save the configuration files to the root directory of the provisioning server.
The following shows an example of SIP account and server redundancy configurations for account 1 (since the IP
phone supports single SIP account) in the configuration files:
##Account Configuration and Registration
account.1.enable = 1
account.1.register.enable = 1
account.1.label = 1234
account.1.display_name = 1234
account.1.auth_name = 1234
account.1.user_name = 1234
account.1.password = 1234
Parameter ValidValues Descriptions WebInterface Path
account.1.sip_server.
Y.failback_mode
(Yrangesfrom1to2)
0,1,2or3
Itconfiguresthemodeforthephonetoretry
theprimaryserverinfailovermodeforthe
account.
0‐newRequests:all requestsareforwardedto
theprimaryserverfirst,regardlessofthelast
usedserver.
1‐DNSTTL:thephonere
triestousethe
primaryserverafterthetimeoutofthe
DNSTTLconfiguredfortheSIPserver.
2‐Registration:thephoneretriestousethe
primaryserverwhentheSIPserver’s
registrationrequiresrenewal.
3‐duration:thephoneretriestousethe
primaryserverafterthetimeoutdefinedby
theparameter“
account.1.failback_timeout”.
Thedefaultvalueis0.
NA
account.1.sip_server.
Y.failback_timeout
(Yrangesfrom1to2.)
Integer0,from
60to65535
Itconfiguresthetimeout(inseconds)forthe
phonetoretrytousetheprimaryserverafter
failingovertothecurrentworkingserverfor
theaccountwhentheparameter
“account.1.sip_server.Y.failback_mode”isset
to3(d
uration).
Ifyousettheparameterbetween1and59,
thetimeoutwillbe60seconds.
Thedefaultvalueis3600.
NA
account.1.sip_server.
Y.register_on_enable
(Yrangesfrom1to2.)
0or1
Itenablesordisablesthephonetosend
registrationrequeststothesecondaryserver
fortheaccountwhenencounteringafailov
er.
0‐Disabled
1‐Enabled
Thedefaultvalueis0.
NA