32
© 2013 McNeilus Truck and Manufacturing, Inc.
Contender Front Loader
Operation
1.2 Warm-Up Procedure
At start-up of the equipment each morning, it is important to
cycle through each of the main hydraulic circuits to be certain
each circuit is functioning properly. Cycling through each
operation also helps ensure that the hydraulic uid is up to
operating temperature and is present throughout the system.
CAUTION
If you detect a problem with any control
function, it must be repaired immediately.
DO NOT operate the Packer with
malfunctioning controls.
Damage to property or equipment may occur.
1. Cycle through each of the following operations:
Pack/Eject Functions - Cycle three (3) times.
Tailgate Functions - Cycle one (1) time.
Top Door Functions - Cycle three (3) times.
Fork and Arm Functions - Cycle ten (10) times.
2. After completing the cycle tests, inspect the refuse vehicle
for any hydraulic leaks. If the leaks are detected, correct them
BEFORE the refuse vehicle is placed into actual operation.
To Next Page
Loading...
