39
© 2013 McNeilus Truck and Manufacturing, Inc.
Contender Front Loader
Operation
1
Figure 11
1.9 End of Day Checks
At the end of the day, make certain that:
1. Pack/Eject is fully retracted.
2. Fork and arm assemblies are fully raised.
3. Tailgate is fully closed.
4. Body (OPTIONAL) is fully lowered.
5. All equipment is properly shut down (see the Chassis
Manual for more information on proper shut-down
procedures for the engine).
2.0 Control Box and Instruments
NOTE
Control configurations and locations may
vary depending upon customer ordered
options.
Your Packer may not have all the features
or options covered in this manual. You
should pay careful attention to the
instructions that pertain to your vehicle. If
your vehicle is equipped with special
equipment or options not covered in this
manual, please contact McNeilus Truck and
Manufacturing, Inc. at 888-686-7278.
The following gures and tables identify and describe the
controls used on the equipment. Not all of the instruments and
controls shown here are on your equipment. Items covering
various models and options are illustrated.
To make sure you understand proper operating procedures,
read this section and carefully practice with the controls and
instruments to learn how to safely operate the equipment.
To Next Page
Loading...
