McNeilus Contender - Installing a Carry Can

68
© 2013 McNeilus Truck and Manufacturing, Inc.
Contender Front Loader
Operation
4.1.1 Installing a Carry Can
CAUTION
The installation procedure must be followed
when installing a carry can.
Failure to follow all these steps may cause
serious personal injury or equipment
damage.
1. Always follow the mandated Lockout/Tagout procedures.
2. Always clear area around arm and fork area in front of the
truck.
3. Fully raise arms to stow arms in hopper.
4. Remove truck key from ignition.
5. Install bumper arm rest pads and secure with pin and
lock.
6. Clear the area, start truck, and lower arms.
7. Insert forks into carry can pockets.
8. Tip forks up slightly to correctly position carry can on
forks.
9. Install carry can spacer tubes and retaining bolts (if
applicable).
10. Remove truck key from ignition.
11. Attach carry can safety chain or strap to or around fork
tube.
12. Attach hydraulic quick disconnects and electrical
connections (if carry can has hydraulic tipper).
13. Start truck, clear the area, and verify the tipper works
properly.
14. Reverse the above process to remove carry can.
15. Call McNeilus Truck and Manufacturing, Inc. at 888-686-
7278 if you require further assistance or have questions.