EasyManua.ls Logo

MDS iNET 900 - RSSI by Zone Menu Screen (Remotes Only)

MDS iNET 900
130 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
42 MDS iNET 900 Users Guide MDS 05-2806A01, Rev. A
Signal-to-Noise (Display only)—Current running-average
SNR value all active operating frequencies.
(No value displayed on APs)
RSSI
(Display only)—Current running-average Received Signal
Strength Indication for all active operating frequencies.
(No value displayed on APs.)
RSSI by Zone—Received Signal Strength Indicator.
(See RSSI by Zone Menu Screen (Remotes Only) on Page 42)
Event Log—Access to the unit’s log of operating events.
(See Maintenance Menu on Page 53)
Packet Statistics—Multiple radio and network operat-
ing statistics. (See Packet Statistics Menu on Page 46)
Wireless Network Status
(Displayed only at Remotes)
Current association state and MAC address of the Access Point.
(See Packets receivedOver-the-air data packets
received by this unit on Page 46)
Remote Listing
(AP Display only) —List of basic information
for all iNET 900 Remote units currently associated with this
Access Point. (See Remote Listing Menu (Access Points
Only) on Page 48)
Endpoint Listing
(AP Display only)List of units accessible
by this AP through associated iNET Remote ports.
(See Endpoint Listing Menu (Access Points Only) on
Page 49)
Remote Performance Listing
(AP Display only)
(See Remote Performance Listing Menu (Access Points Only)
on Page 50)
RSSI by Zone Menu Screen
(Remotes Only)
This screen displays the strength of RF signals from the Access Point.
The MDS iNET 900 network integrity depends partially on stable radio
signal levels being received at each end of a data link. In general, signal
levels stronger than –77 dBm will provide reliable communication that
includes a 15 dB fade margin.
If you find there is a poor signal level on one zone, check the Packet Sta-
tistics Menu section Page 46 and record the values. Then, set the ques-
tionable zone to “Skipped” in the Radio Configuration Menu (Page 29)
and look for an improvement in the Packet Statistics error rates. If there
is none, return the Zone to “Active.”

Table of Contents

Related product manuals