84 MDS iNET 900 User’s Guide MDS 05-2806A01, Rev. A
If the radio network seems to be operating properly based on observa-
tion of the unit’s LEDs, you can use the PING command to verify the
link integrity with the Access Point or pointing your browser to another
Remote unit’s IP address in the same network.
LINK
(Access Point)
ON Default state
Blinking Data Tx/Rx
LINK
(Remote
Gateway)
ON Associated to AP
Blinking Data Tx/Rx
OFF Not associated with AP
Table 3-2. MDS iNET 900 LED Functions (Continued)
LED Label Activity Indication
To Next Page
Loading...
