“4069RT” Service and Parts Manual March 2014
Page XI
F
REE
-W
HEEL
C
ONFIGURATION
F
OR
W
INCHING
OR
T
OWING
RUNAWAY HAZARD!
AFTER RELEASING THE BRAKES THERE IS NOTHING TO STOP MACHINE
TRAVEL. MACHINE WILL ROLL FREELY ON SLOPES.
ALWAYS CHOCK THE WHEELS BEFORE MANUALLY RELEASING THE BRAKES.
The machine can be winched or towed short distances at speeds not to exceed 5 MPH
(8 km/h). Before towing or winching the machine, it is necessary to release the brakes.
Reset the brakes after towing or winching.
D
ISENGAGE
B
RAKES
BEFORE
T
OWING
OR
W
INCHING
• Chock the wheels.
• Press and hold the Brake Release Valve, then slowly press the Hand Pump button on the
Functions Manifold repeatedly until the brakes release (normally 8-10 full pump strokes).
E
NGAGE
B
RAKES
BEFORE
D
RIVING
The brakes reset automatically when the motor is started.
The brakes may be manually applied by pulling the Brake Release Valve out.
BE SURE THAT THE BRAKES ARE ENGAGED BEFORE REMOVING THE WHEEL
CHOCKS.
ART_4293
Hand Pump
Release
Valve
To Next Page
Loading...
