“4069RT” Service and Parts Manual March 2014
Page 2-31
GP400 CONTROL MODULE SETUP CALIBRATION PROBLEMS
Press ENTER when “NO” is displayed if there is no need to redo the LOADED phase.
Press UP or DOWN to display “YES” then press ENTER if it is necessary to redo the
LOADED phase.
If the previous LOADED calibration was in error, or if the pressure sensor is replaced, it
will be necessary to redo the LOADED phase.
TOTAL DATA:
This message is displayed at the end of each phase, to confirm the number of measure-
ments recorded by the GP400. No operator input is required during this process.
To Next Page
Loading...
