MI 3125 / BT EurotestCOMBO Preface
7
1 Preface
Congratulations on your purchase of the Eurotest instrument and its accessories from
METREL. The instrument was designed on a basis of rich experience, acquired through
many years of dealing with electric installation test equipment.
The Eurotest instrument is professional, multifunctional, hand-held test instrument
intended to perform all the measurements required in order for a total inspection of
electrical installations in buildings. The following measurements and tests can be
performed:
Voltage and frequency,
Continuity tests,
Insulation resistance tests,
Earthing resistance tests,
RCD testing,
Fault loop / RCD trip-lock impedance measurements,
Line impedance / Voltage drop,
Phase sequence.
The graphic display with backlight offers easy reading of results, indications,
measurement parameters and messages. Two LED Pass/Fail indicators are placed at
the sides of the LCD.
The operation of the instrument is designed to be as simple and clear as possible and
no special training (except for the reading this instruction manual) is required in order to
begin using the instrument.
In order for operator to be familiar enough with performing measurements in general
and their typical applications it is advisable to read Metrel handbook Guide for testing
and verification of low voltage installations.
The model MI 3125 BT has inbuilt Bluetooth interface for easy communication with PC
and Android devices.
The instrument is equipped with the entire necessary accessory for comfortable testing.
Note:
For some national specific instrument implementations some details in the below
description can differ from the actual instrument implementation. Check the national
specific notes in Appendix C or ask your local dealer.
To Next Page
Loading...
Need help?
General
