METREL EurotestCOMBO MI 3125 - A.2 Fuse table - Impedances at 230 V a.c. (AS;NZS 3017)

MI 3125 / BT EurotestCOMBO Appendix B
77
B Appendix B - Accessories for specific
measurements
The table below presents standard and optional accessories required for specific
measurement. The accessories marked as optional may also be standard ones in some
sets. Please see attached list of standard accessories for your set or contact your
distributor for further information.
Function
Suitable accessories (Optional with ordering code A….)
Insulation resistance
 Test lead, 3 x 1.5 m
 Tip commander (A 1401)
R LOWΩ resistance
 Test lead, 3 x 1.5 m
 Tip commander (A 1401)
 Test lead, 4 m (A 1154)
Continuous resistance
measurement
 Test lead, 3 x 1.5 m
 Tip commander (A 1401)
 Test lead, 4 m (A 1154)
Line impedance
 Test lead, 3 x 1.5 m
 Mains measuring cable
 Plug commander (A 1314)
 Tip commander (A 1401)
 Three-phase adapter (A 1110)
 Three-phase adapter with switch (A 1111)
Fault loop impedance
 Test lead, 3 x 1.5 m
 Mains measuring cable
 Plug commander (A 1314)
 Tip commander (A 1401)
 Three-phase adapter (A 1110)
 Three-phase adapter with switch (A 1111)
RCD testing
 Test lead, 3 x 1.5 m
 Mains measuring cable
 Plug commander (A 1314)
 Three-phase adapter (A 1110)
 Three-phase adapter with switch (A 1111)
Earth resistance
 Test lead, 3 x 1.5 m
 Earth test set, 3-wire, 20 m (S 2026)
 Earth test set, 3-wire, 50 m (S 2027)
Phase sequence
 Test lead, 3 x 1.5 m
 Three-phase adapter (A 1110)
 Three-phase adapter with switch (A 1111)
Voltage, frequency
 Test lead, 3 x 1.5 m
 Mains measuring cable
 Plug commander (A 1314)
 Tip commander (A 1401)