METREL EurotestCOMBO MI 3125 User Manual

MI 3125 / BT EurotestCOMBO Appendix C
78
C Appendix C – Country notes
This appendix C contains collection of minor modifications related to particular country
requirements. Some of the modifications mean modified listed function characteristics
related to main chapters and others are additional functions. Some minor modifications
are related also to different requirements of the same market that are covered by
various suppliers.
C.1 List of country modifications
The following table contains current list of applied modifications.
Country
Related chapters
Modification type
Note
HUN
5.5, 5.6, C.2.1
Appendix A
Appended
Added gR fuse type
AT
5.4, 9.3, C.2.2
Appended
Special G type RCD
NO, DK, SW
4.2, C.2.3
Appended
IT supply system
AUS / NZ
4.2, 4.2.5, 4.2.8,
5.5, 5.6,
Appendix A
Appended
AUS / NZ fuse table added
C.2 Modification issues
C.2.1 HUN modification – gR fuse types
Modifications of the chapter 5.5
Test parameters for fault loop impedance measurement
Test
Selection of fault loop impedance sub-function [Zloop, Zs rcd]
Fuse type
Selection of fuse type [---, gR, NV, gG, B, C, K, D]
Fuse I
Rated current of selected fuse
Fuse T
Maximum breaking time of selected fuse
Lim
Minimum short circuit current for selected fuse.
See Appendix A and Appendix C for reference fuse data.
Modifications of the chapter 5.6
Test parameters for line impedance measurement
Test
Selection of line impedance [Zline] or voltage drop [ΔU] sub-function
FUSE type
Selection of fuse type [---, gR, NV, gG, B, C, K, D]
FUSE I
Rated current of selected fuse
FUSE T
Maximum breaking time of selected fuse
Lim
Minimum short circuit current for selected fuse.
See Appendix A and Appendix C for reference fuse data.

METREL EurotestCOMBO MI 3125 Specifications

General

Brand	METREL
Model	EurotestCOMBO MI 3125
Category	Measuring Instruments
Language	English