METREL EurotestCOMBO MI 3125 - Initial Settings

MI 3125 / BT EurotestCOMBO Instrument operation
27
Commander models
 A1314, A1401: new commanders (more information can be found in Appendix E)
Note:
 Commander disabled is intended to disable the commander’s remote keys. In the
case of high EM interfering noise the operation of the commander’s key can be
irregular.
4.2.7 Initial settings
In this menu the instrument settings and
measurement parameters and limits can be
set to initial (factory) values.
Internal Bluetooth module is initialized. (MI
3125 BT only)
Figure 4.8: Initial settings dialogue
Keys:
TEST
Restores default settings (YES must be selected with
/ keys).
Function selectors
Exits back to main function menu without changes.
Warnings:
 Customized settings will be lost when this option is used!
 If the batteries are removed for more than 1 minute the custom made settings will
be lost.
The default setup is listed below:
Instrument setting
Default value
Contrast
As defined and stored by adjustment procedure
Isc factor
1.00
RCD standards
EN 61008 / EN 61009
Language
English
Commander
A1314, A1401
Internal bluetooth
Initialization of internal Bluetooth module.
(MI 3125 BT only)
Function
Parameters / limit value
Sub-function
EARTH RE
No limit