METREL EurotestCOMBO MI 3125 User Manual

MI 3125 / BT EurotestCOMBO Safety and operational considerations
8
2 Safety and operational considerations
2.1 Warnings and notes
In order to maintain the highest level of operator safety while carrying out various tests
and measurements, Metrel recommends keeping your Eurotest instruments in good
condition and undamaged. When using the instrument, consider the following general
warnings:
 The symbol on the instrument means »Read the Instruction manual
with special care for safe operation«. The symbol requires an action!
 If the test equipment is used in a manner not specified in this user manual,
the protection provided by the equipment could be impaired!
 Read this user manual carefully, otherwise the use of the instrument may
be dangerous for the operator, the instrument or for the equipment under
test!
 Do not use the instrument or any of the accessories if any damage is
noticed!
 If a fuse blows in the instrument, follow the instructions in this manual in
order to replace it!
 Consider all generally known precautions in order to avoid risk of electric
shock while dealing with hazardous voltages!
 Do not use the instrument in supply systems with voltages higher than
550 V!
 Service intervention or adjustment is only allowed to be carried out by a
competent authorized personnel!
 Use only standard or optional test accessories supplied by your
distributor!
 Consider that protection category of some accessories is lower than of the
instrument. Test tips and Tip commander have removable caps. If they are
removed the protection falls to CAT II. Check markings on accessories!
(cap off, 18 mm tip)…CAT II up to 1000 V
(cap on, 4 mm tip)… CAT II 1000 V / CAT III 600 V / CAT IV 300 V
 The instrument comes supplied with rechargeable Ni-Cd or Ni-MH battery
cells. The cells should only be replaced with the same type as defined on
the battery compartment label or as described in this manual. Do not use
standard alkaline battery cells while the power supply adapter is
connected, otherwise they may explode!
 Hazardous voltages exist inside the instrument. Disconnect all test leads,
remove the power supply cable and switch off the instrument before
removing the battery compartment cover.
 All normal safety precautions must be taken in order to avoid risk of
electric shock while working on electrical installations!

METREL EurotestCOMBO MI 3125 Specifications

General

Brand	METREL
Model	EurotestCOMBO MI 3125
Category	Measuring Instruments
Language	English