METREL EurotestCOMBO MI 3125 User Manual

MI 3125 / BT EurotestCOMBO Appendix E
E Appendix E – Commanders (A 1314, A 1401)
E.1 Warnings related to safety
Measuring category of commanders:
Plug commander A 1314 ………… 300 V CAT II
Tip commander A 1401
(cap off, 18 mm tip) 1000 V CAT II / 600 V CAT II / 300 V CAT II
(cap on, 4 mm tip)…1000 V CAT II / 600 V CAT III / 300 V CAT IV
 Measuring category of commanders can be lower than protection category
of the instrument.
 If dangerous voltage is detected on the tested PE terminal, immediately
stop all measurements, find and remove the fault!
 When replacing battery cells or before opening the battery compartment
cover, disconnect the measuring accessory from the instrument and
installation.
 Service, repairs or adjustment of instruments and accessories is only
allowed to be carried out by a competent authorized personnel!
E.2 Battery
The commander uses two AAA size alkaline or rechargeable Ni-MH battery cells.
Nominal operating time is at least 40 h and is declared for cells with nominal capacity of
850 mAh.
Notes:
 If the commander is not used for a long period of time, remove all batteries from
the battery compartment.
 Alkaline or rechargeable Ni-MH batteries (size AA) can be used. Metrel
recommends only using rechargeable batteries with a capacity of 800 mAh or
above.
 Ensure that the battery cells are inserted correctly otherwise the commander will
not operate and the batteries could be discharged.
E.3 Description of commanders
Figure E.1: Front side tip commander (A 1401)

METREL EurotestCOMBO MI 3125 Specifications

General

Brand	METREL
Model	EurotestCOMBO MI 3125
Category	Measuring Instruments
Language	English