4.5 Entering sample data
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
26
￭￭￭￭￭￭￭￭
876 Dosimat plus
4.5 Entering sample data
Menu ▶ Sample data
In the dosing mode DOS, a sample size can be used for calculation.
The sample size can be entered using the keypad (in the main menu under
Sample data) or transferred directly from a balance by means of a cable
connection. When using direct data transfer from a balance, care must be
taken to ensure that the settings for data transfer on the 876 Dosimat plus
match those on the balance (see page 37).
ID1
Sample identification.
Entry max. 10 characters
Default value empty
ID2
Sample identification.
Entry max. 10 characters
Default value empty
Sample size
Sample size.
Input range –999999999 - 9999999999
Default value 1.0
Unit
Unit of the sample size.
Selection g | mg | µg | mL | µL | pieces | User-defined
Default value g
User-defined
A user-defined unit can be created. This will be added to the selection
list. The previous entry will be overwritten as soon as the new unit has
been defined.
To Next Page
Loading...
Need help?
General
