Metrohm Dosimat plus 876 - 4 Operation; 4.1 Switching the instrument on and off

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Operation
876 Dosimat plus
￭￭￭￭￭￭￭￭
17
4 Operation
4.1 Switching the instrument on and off
Switching on the instrument
Proceed as follows:
1
￭ Press the red [FILL] key.
The instrument is initialized and a system test performed. This pro-
cess takes some time.
￭ If a buret unit has been attached, then a request appears to carry
out the PREP function:
All tubings and the cylinder are rinsed with the PREP (Preparing)
function. The preparing of the buret unit is described in chapter
"Preparing the buret unit (PREP)", page 27.
￭ Confirm the message with [OK].
The display of this message can be deactivated in the system set-
tings (see "PREP warning", page 32).
The main dialog is displayed:
Switching off the instrument
The instrument is switched off with the [FILL] key. The fact that the key
needs to be pressed down for an extended time prevents accidental
switch off.