6.1 Manual dosing (DOS)
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
44
￭￭￭￭￭￭￭￭
876 Dosimat plus
where:
Volume Dosed volume
Blank Blank value
Titer Titer of the solution used
Conc. Concentration of the solution used
Factor Factor
Sample size Sample size. The sample size and associated unit can
be specified under Menu ▶ Sample data. If a bal-
ance is connected, the sample size (with unit) can
also be applied directly from the balance.
Divisor Divisor
NOTICE
If a solution is selected in Parameters, the corresponding titer and the
concentration from the solution data in System ▶ Solutions is read
out and used for the calculation. If this is not the case, Default value
1 is used for the calculation.
Calculation status
Activating the calculation.
Selection on | off
Default value off
on
The settings for the calculation can be entered as soon as the calcula-
tion has been activated.
Result name
The result name will be shown in the result view and in the report.
Entry 12 characters
Decimal places
Number of decimal places used to display the result.
Input range 0 - 5
Default value 2
Result unit
The result unit is displayed and saved along with the result.
Proceed as follows if you wish to delete a selected unit:
To Next Page
Loading...
Need help?
General
