Microtest 6632 Series - Page 77

72
<Command> :MEASure:FILE:LOAD?
Function：It queries the meter mode's filename which is being using.
Description：
Query syntax:
MEASure:FILE:LOAD?
Return
dataMICROTEST
<Command> :FETCh?
Function：It fetches the measurement data currently test mode.
<Command> :CORRection:OPEN
:CORRection:OPEN?
Function：It sets or queries to do open correction.
Description：
Query syntax
:CORRection:OPEN?
Return
data When correction fail, it returns 0.
When correction passes, it returns 1.
<Command> :CORRection:SHORt
:CORRection:SHORt?
Function：It sets or queries to do short correction.
Description：
Query syntax
:CORRection:SHORt?
Return
data When correction fail, it returns 0.
When correction passes, it returns 1.
<Command> :CORRection:OPEN:STATe {OFF|ON|0|1}
:CORRection:OPEN:STATe?
Function：It sets or queries the status of open correction.
Description：
Query syntax
:CORRection:OPEN:STATe?
Return
dataWhen the setup is OFF, it returns 0.
When the setup is ON, it returns 1.
<Command> :CORRection:SHORt:STATe {OFF|ON|0|1}
:CORRection:SHORt:STATe?
Function：It sets or queries the status of short correction.
Description：
Query syntax
:CORRection:SHORt:STATe?
Return
dataWhen the setup is OFF, it returns 0.
When the setup is ON, it returns 1.
<Command> :CORRection:CABLe {0|0.5|1|2}
:CORRection:CABLe?
Function：It sets or queries the status of cable length correction.
Description：
Query syntax
:CORRection:CABLe?
Return
data0|0.5|1|2
There are two options for trigger and query：
1. Give command *TRGor :TRIG? and get measuring result (recommend)
2. Give command :TRIGfor trigger and give :FETCH? to get measuring result
To be sure currently step is under MEAS mode, or give command :DISP:PAGE MEAS to enter
MEAS mode.