Midmark M11 - To Replace the Temperature Sensor

English-105
004-1032-00
TP210 Rev. A
© 2012 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
[Revised: mo/dd/yr]
Temperature Sensor - continued
Replacement
Service Tip:
Residue build-up can cause inaccurate temperature / pressure readings.
Clean the sensor probe with Speed-Clean and distilled water.
To replace the temperature sensor...
A) Disconnect sensor harness from J12 on PC board.
B) Remove temperature sensor.
C) Apply hi-temp hydraulic sealant (Loctite 565) to
temperature sensor threads. Do not use teflon tape!
D) Install temperature sensor.
E) Connect sensor harness to J12 on PC board.
J12
MA664700i
J12
Apply hi-temp hydraulic
sealant to sensor threads.
midmark.com
Style A