Midmark M11 - Interactive Mode; Low Pressure; Low Temperature

English-9
004-1032-00
TP210 Rev. A
© 2012 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
[Revised: 8/15/17]
Low Temperature
Low Temperature. Maintenance not performed. Verify weekly & monthly maintenance has been
performed by customer. Refer to User Guide.
Perform monthly maintenance.
Temperature sensor malfunctioning. Check for residue build up on temperature
sensor probe.
Clean sensor probe with Speed-Clean,
distilled water, and abrasive pad.
Check that nothing is touching or crowding
the temperature sensor.
(Example: trays, pouches, cassettes, etc.)
Reposition items so nothing touches or
crowds the temperature sensor.
Pressure Leaks. Check for loose / worn door and dam
gaskets or water leaking around door.
Verify door and dam gaskets are installed
properly. (Replace gasket kit 1x year)
Clean / Replace gaskets.
Check all plumbing fitting connections for
leakage.
Tighten or replace fittings.
Interactive Mode
SW1 Switch Settings. SW1 switch #6 is in the “on” position. Check position of switch #6.
Refer to: SW1 Switch Settings
Turn off SW1 switch #6.
Message will not reset. Move switch #6 on/off. Unplug unit for 60
seconds, then plug unit into a dedicated,
properly rated circuit.
Replace Main PC board.
Low Pressure
Low Pressure. Low Pressure during cycle. Check where in cycle error occurred. Explain Display message.
Door / Dam gasket(s). Inspect door / dam gaskets for proper
installation and any signs of sticking.
Install door / dam gaskets properly.
If new gasket, check if wire ring in gasket is
preventing gasket from fully being seated.
Temporarily remove wire ring.
Re-install wire ring after gasket is fully
seated.
Maintenance not performed. Verify weekly & monthly maintenance has been
performed by customer.
Refer to User Guide.
Perform monthly maintenance.
midmark.com
Style A