English-73
004-1032-00
TP210 Rev. A
© 2012 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
[Revised: mo/dd/yr]
Using a Pressure Gauge
Note
To test chamber pressure, a Pressure Gauge Harness is available (002-0372-00).
Step 1: Connect the pressure gauge.
A) Cut cable tie, then disconnect tubing from PC board.
B) Connect pressure gauge harness as shown.
Step 2: Verify correct pressure display.
A) Run a sterilization cycle.
B) The pressure shown on the gauge should match the
pressure on the display panel.
Step 3: Remove gauge / Connect tubing.
A) Disconnect pressure gauge harness.
B) Connect tubing to PC board.
C) Secure tubing with high-temp cable tie.
To Next Page
Loading...
