English-118
004-1032-00
TP210 Rev. A
© 2012 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
[Revised: mo/dd/yr]
Printer - continued
Testing
Printer: Supply Voltage Test
A) Disconnect sensor harness from J14 on PC board.
B) Set meter to ‘20 VDC’
C) At J14 on PC board, place meter probes on pins 7 & 8 as shown.
Meter Reading Required Action
acceptable range: 4 to 6 VDC Perform continuity test on printer harness.
If broken wires are found, replace harness.
If harness is OK, replace printer.
any reading out of the
acceptable range
Replace Main PC board
To Next Page
Loading...
